Custom Snapmaker U1 Firmware

Installation Guide

This guide covers installing custom firmware on your Snapmaker U1 3D printer.

Warning: While installing custom firmware does not automatically void the product warranty, any damage caused by or attributable to the installation or use of custom firmware is not covered under warranty. Use at your own risk. See Snapmaker Terms of Use for details.

Custom firmware is intended for users with appropriate technical knowledge. Ensure you understand the implications before proceeding.

Prerequisites

• USB drive formatted as FAT32
• Downloaded firmware .bin file from Releases

Installation Steps

1. Download Firmware
   • Get the latest .bin file from the Releases page
   • Choose between Basic or Extended firmware:
     • Basic - Stock firmware with SSH access and minimal debugging features
     • Extended - Heavily expanded with hardware accelerated camera (WebRTC), RFID support, remote screen, monitoring, and extensive customization
2. Prepare USB Drive
   • Format a USB drive as FAT32
   • Copy the downloaded .bin file to the root of the USB drive
3. Install on Printer
   • Insert the USB drive into the printer
   • On the printer touchscreen, navigate to: Settings > About > Firmware Version > Local Update
   • Select the .bin file from the USB drive
   • Confirm the installation
   • Wait for the update to complete (printer will reboot)

Post-Installation

After installation, the printer will automatically reboot.

Next Steps:

• SSH Access - Access printer via SSH
• Firmware Configuration - Customize firmware behavior (Extended only)
• Camera Support - Configure WebRTC camera streaming (Extended only)
• Remote Screen - Enable remote screen access (Extended only)

Reverting to Stock Firmware

If you need to revert to the original Snapmaker firmware:

1. Download the official .bin file from the Snapmaker U1 Wiki
2. Follow the same installation steps as above

Troubleshooting

• Update fails: Ensure the USB drive is formatted as FAT32
• File not found: Make sure the .bin file is in the root directory of the USB drive
• Printer won’t boot: Try reverting to stock firmware
• For additional help, open an issue on the GitHub repository